Industry
Castings for power generation
In short
Power plants rely on castings that hold steam pressure at high temperature for years. H.J. MetalCraft casts chrome-moly alloy, carbon and stainless steel valve, pump and high-temperature components up to 180 kg, heat-treated and tested in-house.

Pressure plus temperature
Steam, feedwater and cooling systems put castings under combined pressure and heat for long periods. Above roughly 425 °C carbon steel starts to lose strength through creep, which is why chrome-moly grades are specified for hotter service.
Castings used in power plants
- Valve bodies and bonnets for steam, feedwater and cooling lines
- Pump casings and impellers for water and condensate
- Boiler and burner parts in heat-resistant steels
- Couplings and general engineering parts
Typical material choices
| Service | Common grades |
|---|---|
| Water and moderate-temperature steam | ASTM A216 WCB / WCC |
| High-temperature steam | ASTM A217 WC6, WC9, C12 |
| Cooling water, condensate | CF8 / CF8M stainless, CA6NM for impellers |
| Burners, supports, hot-zone hardware | ASTM A297 HH / HK |
Proven properties
Alloy steels only reach their properties with the right heat treatment. We quench, normalise, anneal and temper in-house, then confirm tensile strength, 0.2% proof stress and hardness on our own equipment before NDT and dispatch.
Frequently asked questions
Which cast steel is used for high-temperature steam valves?
Chrome-moly grades such as ASTM A217 WC6 (1.25Cr-0.5Mo) and WC9 (2.25Cr-1Mo) are widely used for high-temperature steam valves because they resist creep better than carbon steel.
Do you test proof stress?
Yes. Our electronic universal testing machine (200 kN) with strain-gauge extensometer measures 0.1% and 0.2% proof stress and Young's modulus.
